B07HFL9NZH
September 18, 2018  |  Outdoors

SpaGuts Topside Command Center Kit, 110V, 2-Button Overlay, 6ft Power Cord and Sensor
classic space

SpaGuts Topside Command Center Kit, 110V, 2-Button Overlay, 6ft Power Cord and Sensor

     .

  • Make sure this fits
    by entering your model number.


  • 1x Command Center with Display, Standard, 120V, 6ft Cord, 6ft Sensor, CC4D-120-06B-00


  • 1x Overlay, 2-Button Label, W/Display, 30215BM


  • 2x Nylon Washer, 20149AM


  • 1x Dial Knob, 30175BM


  • 1x Mounting Template, AM30198; 4x Mounting Screws, 3/4-inch long

SpaGuts 30-200-1016. If you have a pneumatic (air) spa controller with HEATER but would like the convenience of being able to not only control the temperature from a topside control unit, but to also see an LED display of the water temperature, this standard topside command center is for you. This is a must if you have limited access to your spa equipment or if you would prefer not getting out of the hot tub every time you want to adjust the temperature. This topside WILL NOT work with the Heat Recovery Control unit from TecMark. Standard Dimensions (Approx): 6.50 inches L x 3.25 inches W x 4.50 inch D. Keep in mind that most Command Centers are rated 110 or 120 volts. Verify off the original topside label or take voltage measurement off the 6-pin receptacle for voltage rating. Newer model Topside Command Centers will only have 5-pin plugs as shown in photo, which will work fine on a 6-pin receptacle. The 5-pin plug style is UL approved for safety standards. Thermowell is sold separately. NOTE 1: This topside command center only works with pneumatic (air) type controllers that is topside ready with a 6-pin receptacle installed. This topside WILL NOT work with the Heat Recovery Control unit from TecMark. NOTE 2: This topside command center has an LED display that also needs constant power to the display at all times in order for the thermostat to work. If the LED display version is replacing an old topside command center that has no LED display, customer MUST be willing to re-wire the main controller box to provide constant power to the new topside with LED display. NOTE 3: A few controllers out there are pre-wired for a topside command center with no display. Customer MUST be willing to re-wire the main controller box to provide constant power to the new topside with LED display. Normally this is determined by having to turn on the blower circuit in order to get the LED display to light up.

Product information

Product Warranty: For warranty information about this product, please click here

Would you like to tell us about a lower price?

GET MORE DETAILS HERE


Comments are closed.

Copyright © 2018 · Classic Space | Powered by where to buy