Make sure this fits
by entering your model number.
Quick results, with your first radon level indication in 24 hours
Lightweight and portable
Battery operated with a 2-year battery life
Unaffected by electromagnetic interference and dust, performs optimally in humidity < 85%
Designed in Europe and tested in Japan, Germany, France & USA
The Corentium Home by Airthings radon detector is a state-of-the-art measuring instrument that combines ease of use and performance. The Corentium Home by Airthings radon gas detector allows you to take a reading of the radon levels and its LCD screen displays the average daily, weekly and long term concentrations. Powered by 3 standard AAA batteries, the radon monitor makes it easy to take measurements from one room to another in order to get an overview of the concentrations of radon in a home, workplace, school, a daycare centre or any other location. The Corentium Home by Airthings radon detector is also an essential tool to use when performing property inspections or when checking the operation of a radon mitigation system. The internal architecture of the Corentium Home by Airthings radon monitor comes from advanced technology normally reserved for commercial-type detectors. Particular attention has been paid to the quality and protection of the internal components, allowing the use of algorithms for signal analysis that are more sophisticated. The Corentium Home by Airthings radon gas detector quickly adapts to its environment and eliminates inaccuracies related to external factors, allowing it to obtain the best accuracy in its niche. The Corentium Home by Airthings radon monitor is guaranteed for one year and in normal home use, it requires no annual calibrations throughout its useful life, estimated at over 10 years.
-The radon mitigation fan that was installed in my house, which is working in the green (according to its vacuum indicator), does essentially nothing to reduce radon levels. On or off, same averages. *See update below, I don’t believe this to be completely accurate anymore. Just don’t RELY on your radon fan as your only means of protection.
-The radon levels can swing WILDLY when air-moving appliances are in use. My basement averaged around 1 pCi/L for months, then shot up to over 5 when we began running the heater. I believe the heater was lowering the relative pressure in the basement (exhausting air via flue), causing far more gas to be sucked in through the cracks in the concrete slab and foundation walls. I’m currently in the process of remedying that, and this tool gives me the info I need to know if my changes (patching cracks, ventilation, etc) are making a difference. We’re seeing our radon drop to the lowest levels yet due to our improvements, thanks to the help of this tool letting us know what is working and what is not.
You simply CANNOT rely on some “professional” coming into your house and testing your radon level, even if tested over a long period of time. The average radon level in your house over a week or month is meaningless when it can change so drastically month to month. If you live in a place where radon is known to be problematic (I’m in CO), then you need continual monitoring.
After a lot more testing, I’ve come to appreciate my 80 watt radon mitigation fan that pulls air from beneath my basement slabs. With it on, a few windows cracked, and the central air intake in the basement sealed to increase relative pressure, I’ve managed to get radon averages from 5 pCi/L (dangerous) to 0.50 pCi/L (safe) regardless of the heater occasionally running.
April 5, 2014
In Feb 2016 I ran another side by side comparison of the Corentium 223 vs the SS (Safety Siren), and this time using two charcoal tests as “controls.” All four were placed around the same spot (pictures do not show the charcoal tests but they were right next to the Corentium and SS). The Corentium and the SS were turned on at the same time and allowed to run until the SS started to show a result (due to the SS not showing an initial reading until a couple days after turning it on or resetting it, whereas the Corentium starts showing a reading almost immediately).
Once the Corentium and SS were on for a few days I opened both charcoal tests and left them open for 4 days (the longest time allowed by the lab to get legitimate/accurate results). Then I sealed up the charcoal tests and mailed them in and checked the readings of the Corentium and the SS which had now been on for 7-days (the reason for 7 days is that the devices both provide readings at 7 days but other readings are at different time parameters and so not comparable). The results are shown in my pics (3rd-6th pics).
Charcoal Test #1: <0.5 pCi/L
Charcoal Test #2: <0.6 pCi/L
Corentium 223: 0.97 pCi/L (“7 days” reading)
Safety Siren: 1.2 pCi/L (“S”=7 days reading)
Please note that I bought both the Corentium and the SS in March 2014 and so both were almost 2 years old at this point. I’m not sure the charcoal test results and those of the Corentium and the SS can be compared directly since their readings are over different times (approximate 4 days for the charcoal test vs 7 days for the two devices; I had to do this since the charcoal tests cannot be tested for more then 4 days and the two devices do not show readings at shorter times (e.g. 3 days, etc.).
Interpreting the results is not exactly easy or maybe even valid, but it does at least seem to show that the devices are not wildly different than the charcoal readings and more importantly, they seem to read higher rather than lower than the charcoal readings (i.e. they do not give falsely low readings). It also shows that the charcoal tests are very close to each other and therefore probably a reliable test (i.e. repeated testing yields values close in value to each other) and are assumed to be the most accurate way to test radon levels. Another finding is that the SS, which needs re-calibration annually, had higher values compared with the Corentium (which is not supposed to need retitration over the life of the device which is stated as about 10 years). However, when I left the two devices on for a few more days (see the 6th pic) I found that the values became much closer to each other: 0.9 for the SS and 0.94 for the Corentium.
Conclusions? I would say that based on my amateur and non-expert tests and interpretation of the results, that both devices are probably reliable and accurate enough to get a decent approximation of the radon levels in your home. The SS, though cheaper than the Corentium, is uglier and needs a wall power adapter whereas the Corentium is smaller, better looking, lasts a long time on batteries, and can be hung on the wall. It also reportedly does not need re-calibration for the 10 year lifespan and so I consider the Corentium to be a superior device and would recommend it over the Safety Siren.
[Update 1: March 2015]
Sorry to the folks who were waiting to see the results of my side by side comparisons between this device, the Safety Siren, and the charcoal mail in tests. I’ve attached a photo of both detectors (along with the charcoal test, only did one of those) side by side after both had been sitting there for over a week. As you can see, the Safety Siren is set to short term reading, which I believe is the past 7 days reading, and shows at 1.6 while the Corentium shows 1.64 and is for the past 7 days also. So, based on this test (and I’ve done this several other times with the same, comparable results) both detectors seem to give similar readings.
Of course, the gold standard seems to still be the charcoal, mail in kits and so I’ve attached a photo of that reading too. Basically, the kit shown in the pick was set out for the required time (48 hours) and mailed in promptly. The reading I got back from the company was 1.7 pCi/L, so pretty close to both detectors. The Safety Siren only goes to one decimal place and so is a bit more limited than the Corentium which goes out to 2 decimal places, but in reality 2 decimal places is probably not very valuable or helpful.
So, to summarize, my test did show that the device is pretty accurate compared to a charcoal test and also that the Safety Siren was comparable — although that device does not run on batteries and apparently needs to be recalibrated on an annual basis or so. The Corentium supposedly does not ever need to be recalibrated which just seems really odd to me. I will repeat these tests periodically and update this review on an annual basis (or until a better detector comes out than either of these!) to see how well the Corentium stands up over the years with regards to calibration need. I have also upgraded my rating to 4-stars.
[Original Review: April 2014]
Just want to point out that this radon detector does not wait for a couple days to give an initial radon reading, like some detectors do (like the Safety Siren Pro Series3 Radon Gas Detector – HS71512 by Family Safety Products, Inc. does), so basically within a minute or so of turning this device on for the first time (or after resetting), you will start to get initial readings that are predictably around 0.00 pCi/L. Obviously, getting a reading after 10 seconds isn’t helpful, and I don’t understand why it would give a worthless reading instead of making you wait for the necessary time (typically 2 days with the Safety Siren Pro detector) before giving you a reading.
Over the next days/weeks, the reading will often steadily increase for the same reason, making you really question how useful this device is unless you wait at least a week or so. Even then, you’re not sure if the 7-day reading is a weighted average — meaning that those early really low readings would bring the average rating lower than it actually is. When I placed the Safety Siren Pro and the Corentium side by side for about 2 days in my basement near my sump pit, the readings were dramatically different: the Safety Siren gave a 1.7 and the Corentium around 0.56. Over the next couple days (again, the initial readings were after 2 days already), the Corentium reading starting to creep upwards, going from mid-0.5s to around 1.0 and then above, while the Safety Siren Pro stayed fairly steady around 1.7 Another couple days may bring the Corentium to around the reading of the Safety Siren Pro, which would make me feel better that they’re both reliable if given enough time.
I have ordered some charcoal testing kits (which get sent and read by a lab) to use as a kind of reference testing (supposed to be the best way to test apparently) to see which, if either or both, is accurate in detecting radon levels. I will update this review when it does come back, but preliminary testing with the Corentium leaves me unimpressed, especially for the hefty price tag.