How to Fix a Igloo Mini Fridge

how to fix a igloo mini fridge

If you own an Igloo mini fridge, then you’ll know how frustrating it can be when it starts to breakdown. While the cost of a repair may seem like an unaffordable expense, there are some simple ways to fix your fridge so it’s back up and running in no time. The first thing you’ll want to check is the circuit breaker. You’ll also want to make sure the condenser fan motor is working properly. Next, you’ll want to replace the compressor relay.

Checking the circuit breaker

Checking the circuit breaker to fix an igloo mini fridge is a smart thing to do. You don’t want to leave a refrigerator plugged in for an extended period of time because it could result in an electrical shock. It also makes sense to check for loose connections, burned out wires, and other issues.

One of the most common reasons that a mini fridge will trip is a faulty power cord. In order to repair the problem, you need to remove the outlet cover and take a look at the pigtail. This is a small wire connected to the back of the unit that helps transfer power. If it’s a loose connection, you’ll need to replace it.

The same goes for the GFCI (Ground Fault Circuit Interrupter) built into the outlet itself. When water touches the circuit, the GFCI will turn off the appliance. However, if multiple appliances are plugged into the same circuit, the GFCI won’t be able to handle the load.

A good rule of thumb is to never share a power source. While it may be tempting to plug your igloo mini fridge into a neighbor’s, sharing a source of power can result in a blowout, which is not what you’re after.

Checking the condenser fan motor

If your igloo mini fridge is not getting cold, it’s likely that you need to check the condenser fan motor. A refrigerator that is not cold will struggle to exchange heat with the freezer, and you may need to replace a damaged part.

To diagnose the problem, first remove the rear panel from the appliance. Look for a sticker that holds the fan in place. You can then take a multimeter and test the continuity between the motor wires.

The evaporator fan may also need to be checked. This fan draws air from the evaporator coils to cool the inside of the refrigerator. It may be broken, or the blades might be wrapped with dirt.

You can also use a vacuum to clean the condenser coils. If you’re unsure how to do this, consult your owners manual.

You’ll also want to look at the drier filter. This filter helps to keep water condensation from clogging up the compressor. Clean it, and you should get the ice removed.

Finally, you’ll need to check the thermostat. It’s located behind the console in your refrigerator. In some cases, it’s low on the frame of the door. When it’s broken, it will prevent the motor from starting.

Replacing the compressor relay

If your Igloo mini fridge is not cooling, you may need to replace the compressor relay. This is an easy and inexpensive repair. The relay is a two piece unit that plugs into the side of the compressor.

It provides power to the compressor. You may also need to replace the thermostat switch.

First, make sure the electricity is working. Your refrigerator should be on a cold setting. Also, check the temperature thermostat to see if it is sending power to the compressor.

Next, use a multi-meter to test the start relay for electrical current. A good indicator of a good start relay is a click.

Another good indicator is a flashing light. In some cases, the start relay is encased in a white and tan box. When a light comes on, it’s likely you have enough power.

Finally, take the time to look for signs of overheating. This can occur if you share the power source with another appliance or if you have a control board installed.

One of the most common problems with your mini fridge is the starter relay/overload protector. It is a small plastic box that contains several wires.

You can remove the relay switch and test it for continuity with a multi-meter. You should be able to find a replacement for around $30.

Available for Amazon Prime