How To Start A Sun Joe Electric Mower And Avoid Accidents

sun joe electric mower won t start

How To Start A Sun Joe Electric Mower And Avoid Accidents

This article will show you how to start the Sun Joe Electric Mower in the first time. This mower is a great tool to use for trimming your grass in the winter. If you have trouble starting them when they are cold, you can warm them up before you start using it. That way, the motor will be ready and you won’t have any trouble starting it. Following the steps outlined below will help you to start the electric lawnmower in the right way.

On the left side of the controls, there will be a button labeled’start’. You need to push this button to start the machine. The reason why you need to push this button is that it starts the motor. However, if you want to start the mower, you should first unplug it from the power source.

Secondly, you need to turn the engine off. There is a switch on the control panel which will start the engine when switched on. If you want to start the mower, you should first switch on the switch. After you switch on the switch, the battery should start to charge.

Thirdly, you need to start the mower by turning the ignition switch on. Now press and hold the start button while pressing the tailgate. The reason why you have to do this is because this is what starts the vehicle’s battery. When you do so, the battery should be fully charged. To start the motor, you need to push down the same button that you pushed in order to charge the battery.

Fourthly, you should push the start button again. Once the mower starts, you should notice that the tailgate is opening and the engine is running. When the engine is running, the battery is charged and should be ready to use. You should note that the start button does not automatically start the engine. In fact, it needs to be pressed for it to start.

Fifthly, you should plug the mower into an outlet. After you have done so, you should wait for the battery to charge. The maximum time for the mower to charge is about half an hour. Once the battery has been fully charged, you should note that it is ready for use. You should not start using the mower until the battery is fully charged. Otherwise, you will find that the mower will not work properly.

When you find that the mower is already started, you need not do anything else. The mower will start turning immediately when you put your finger on the switch. However, you should ensure that the engine is cranking and there are no objects or road blocks in the way to start the machine.

Now that you know how to start a Sun Joe electric mower, you can stop using it immediately once the blades are spinning. There is nothing wrong with the mower. It will only slow down as it starts slowing down. Take good care of it and keep it in good working condition.

Before you begin mowing your lawn, you should turn off the engine and disconnect the power source. In this case, you should also remove the key from the ignition. Once you have done so, you can begin unscrewing all the nuts and bolts and then loosen them up enough that you can take out the spark plug located in the middle of the main combustion chamber.

Once you have taken out the plug, you should proceed to removing the gaskets found at the rear of the appliance. After you have removed them, you can disassemble the combustible material found in the fuel tank. This will enable you to get to the spark plug if you need to replace it. If the unit is still under warranty, you need to take it to the authorized service center for repairs. Otherwise, you can attempt to repair it yourself.

When the plug is out, you should check if the battery is still inside. If it is, you should place a bag filled with coolant or a heating element on the battery. You need to heat it up for about 10 minutes to ensure that the battery is warm enough before plugging it back in. After doing so, you should check to make sure that there is no leaking at the plug. If you do, you should place a new one in the place of the previous one.

If the above mentioned steps do not solve the problem, then you might have to perform a safety check as well. Make sure that there are no objects or debris within the path of the blades. The blades are usually made to work in tight places, so you should always make sure that they are completely clean before plugging in your electric mower. In case you find any object or debris within the path of the blades, you should immediately remove it so as to avoid an accident.

Available for Amazon Prime