Pyle 5 Channel Home Audio Power Amplifier Mixer w/ 70V Output – 600 Watt Rack Mount Stereo Receiver w/ AM FM Tuner, Headphone, Mic Talkover for PA System Great for Commercial Entertainment Use – PT610

600 WATT POWER: The Pyle 5 Channel Power Amplifier Mixer is perfect for your PA and commercial entertainment system. It gives you 600W peak power to be used for multi speakers w/ 4-16 ohms impedance allowing you to enjoy high quality audio
SPEAKER TERMINALS: The professional integrated indoor outdoor stereo receiver allows you to connect one or more 4-16 ohm speakers to the amp w/ or w/o transformers. Make sure that all connected speakers should have the same impedance rating
BYPASS / EQ SWITCH: The compact and rack mount amplifier features a bypass and EQ switch. Set the switch to EQ position to connect an equalizer, and set to bypass position to remove the effect of the equalizer on your systemâs sound
USEFUL INDICATORS: The sound amplifying device features protection indicator where LED is illuminated when a thermal overload is present, and a clip circuit indicator which protects the amplifier system from being damaged by overdriving power levels
BYPASS / EQ SWITCH: The compact and rack mount amplifier features a bypass and EQ switch. Set the switch to EQ position to connect an equalizer, and set to bypass position to remove the effect of the equalizer on your systemâs sound
5 Channel Mixer – Front 3.5mm AUX CD Input Jack – MIC 1 Talkover – Ground Screw
4 Mic Inputs XLR & 1/4” Combo Jack – 4 ohm, 8 ohm, 16 ohm & 70V Screw Terminals – Headphone Output – 2U Rack Mountable

PyleHome Model : PT610

19” Rack Mount 600 Watt Power Amplifier/Mixer w/ 70V Output & Mic Talkover

5 Channel Mixer

4 Mic Inputs XLR & 1/4” Combo Jack

2 Line Inputs RCA

CH4 Mic/Line Switchable

Effects Loop RCA In/Out

Front 3.5mm AUX CD Input Jack

4 ohm, 8 ohm, 16 ohm & 70V Screw Terminals

8 ohm 1/4” and Binding Post Outputs

Illuminated VU Output Level Meter

Feedback Filter with Rotary Control

MIC 1 Talkover

Headphone Output

Rotary Channel & Master Level Controls

Thermal Overload Protection w/ Indicator

Clip LED Indicator

Ground Screw

2U Rack Mountable

110/220 Voltage Selector

Dimensions: 4 3/16”H x 19.0”W x 12”D

Weight: 22.3 lbs

This rack-mountable, 5-channel power amplifier has power – 600 watts! On the back, it’s equipped with 4 mic inputs, each of which can take balanced XLR or Â¼’ jack inputs – and a rotary-controlled filter prevents excessive feedback. It also has 2 RCA line inputs – so you can connect another source like a CD or MP3 player. This amp is also compatible with speakers of various impedance – it has screw terminals for 4, 8, and 16 ohm speakers, as well as an 8 ohm binding post output. The in/out effects loop allows you to process your signal using an external device. On the front, an illuminated VU meter provides signal levels. A headphone jack lets you hear your mix in private. The PT610 has thermal overload protection with indicator, so you know your sound is secure. Runs on 110 and 220 V.

Product information

Product Dimensions

19 x 12 x 5.2 inches

Item Weight

22.3 pounds

Shipping Weight

25 pounds (View shipping rates and policies)

Manufacturer

Sound Around

ASIN

B000165DSW

Shipping Advisory

This item must be shipped separately from other items in your order. Additional shipping charges will not apply.

Item model number

PT610

Customer Reviews

Best Sellers Rank

#45,287 in Electronics (See Top 100 in Electronics)

#74 in Musical Instruments > Live Sound & Stage > Power Amplifiers

#107 in Electronics > Home Audio & Theater > Home Theater > Receivers & Amplifiers > Receivers

#244 in Musical Instruments > Live Sound & Stage > Monitors, Speakers & Subwoofers

Date first available at Amazon.com

December 10, 2003

Manufacturerâs warranty can be requested from customer service. Click here to make a request to customer service.

Would you like to tell us about a lower price?

February 22, 2017

Verified Purchase

Very pleased with my purchase. I run 12 speakers in series with this and it has plenty of power. I wasn’t so much concerned with power and concert sound with my ceiling time mount pyle speakers but they will rock. What was important to me since they were going in a coffee shop was good clarity on low volume. The receiver does a lot more than I use it for. The only thing I can think of to improve would be built in bluetooth. It didnt come with this model but I bought an adapter and it works great.

September 12, 2014

Verified Purchase

A powered mixer is required for balanced inputs. It has XLR connectors but they are not powered. Sound quality is mediocre even with a good powered mixer and the clipper indicator is only an on/off light instead of analog meter. After 2 years an AGC circuit inside has begun causing trouble. When a wireless mike is only slightly over-modulated on one input, it blanks the sound for the wired mike on another channel. Documentation for this equipment is minimal and difficult to understand.

May 1, 2017

Verified Purchase

works well in our Legion Hall .. we use the 70v side of the amp along with the GTD Cordless mic System

February 2, 2014

Verified Purchase

First, this is not a really a home use item. It is an inexpensive but capable amp/mixer combination that is working very well in our small church. It is a mono amp which we are running with a 70v system of speakers. The sound from the moment we turned it on has been great for our purposes, which are a pulpit mic, wireless lapel mic, and mic for the Lord’s Supper table. It picks up well and clearly and without distortion. Can’t beat if for the price!

December 16, 2016

Verified Purchase

The company had an old 610. It might have been 6 years old. The unit started to act up, cutting out in the middle of a talk. I like to the unit it self. I started looking an found one on Amazon. The only thing that concerns me is the power button sticks sometimes. Everything else is great.

June 2, 2016

Verified Purchase

Works great. Awesome sound quality.

February 18, 2013

Verified Purchase

Our installation is telephone system ringing/paging module fed into the amplifier, then through about 600 feet of 22 gauge (gasp) wire to two 70v horns. This had been working fine for about ten years with a Bogen amp then a Radio Shack amp (both taken out by a power surge after a lightning strike). We selected this amplifier because the price and features list, knowing we were about to change phone systems and would need a rack-mount unit.

With both telephone systems, the Pyle amp would shut down with a fuzz noise through the speakers. This would happen several times a day for a period of a few days. Then the system would work fine for a few days. When we changed telephone systems, we moved the amp to within 100 feet of the horns. Still the same problem, but not as often. At Pyle’s suggestion, we ran 12 new gauge wire to the speakers. Same problem.

So… Can’t blame the input. Can’t blame the wiring. Can’t blame the speakers.

We replaced with a Bogen amplifier and had no problems since.

You’d expect me to give this review a “zero stars” rating. But, if the amp will work for you, it’s a great value for the money!

March 29, 2017

Verified Purchase

Works but over heats easily with rack mount fans installed..!!!!

GET MORE DETAILS HERE