Whirlpool Mini Refrigerator Not Working?

whirlpool mini refrigerator not working

If your Whirlpool mini refrigerator is not working, there may be a few problems that need to be addressed. These include problems with the evaporator fan motor, the control board, the defrost timer, or the drier filter. Here are some troubleshooting tips for your fridge.

Problems with evaporator fan motor

If the evaporator fan on your Whirlpool mini refrigerator is not spinning, the problem may lie with the fan motor. This component is located above the evaporator coils. Generally, you can remove the fan motor by unscrewing it and pulling it downward. You can also use a continuity tester to check the motor’s electrical state. Alternatively, you can seek help from a professional technician or take the refrigerator to a shop for repair.

If the evaporator fan motor on your Whirlpool mini refrigerator does not spin properly, you may need to check the motor’s resistance. If the motor turns on when the freezer switch is depressed, then it is likely that the motor is working properly. If it does not spin properly, however, it is highly likely that the fan is malfunctioning. In this case, you should consider getting a replacement for the motor.

Another cause for fan malfunction can be a shorted wire. If you have access to the motor, you can remove the water inlet valve and disconnect the wire harness from it. You should also clean the condenser coils with a vacuum cleaner to remove any accumulated debris. You should make sure that the fan is clean, free of any obstructions and that it turns freely when the refrigerator is switched off. Similarly, you should vacuum the coils every six to one year to avoid the motor from overheating and causing a problem.

Problems with control board

If you’re having trouble cooling your mini refrigerator, the control board may be the problem. This electronic component controls the compressor and defrost heater and acts as a clock inside the refrigerator. If the board is faulty, the refrigerator can either stop working or behave erratically. The board is also vulnerable to power outages and static electricity.

First, you’ll need to remove the control panel. You can unscrew this with a flathead screwdriver. Once you’ve removed the control panel, you’ll need to remove the electronic control board. Make sure you remove it carefully and install a new one. In some cases, a faulty control board can cause the refrigerator to turn on and off over.

Another problem with a refrigerator is a bad motor. This component should be replaced if the unit will not start. If the compressor were to stop working, the unit would not cool, even with the lights on and the fans blowing.

Problems with defrost timer

If the defrost timer on your Whirlpool mini refrigerator isn’t triggering the defrost cycle, it may be due to a problem with the defrost timer. This problem can be fixed by a professional Whirlpool refrigerator repairman. You can also try to clean the refrigerator yourself with water and mild soap. Once you’ve cleaned the appliance, allow it to air dry.

To diagnose a faulty defrost timer, first check the refrigerator’s control housing. It will be located at the bottom of the fridge, behind the kick plate, and at the back. If you can’t find it there, open up the fridge’s control panel and unscrew the screws that hold the defrost timer in place. You can then check whether the defrost timer is mechanical or electrical. If it’s the former, make sure the defrost timer has been replaced.

Problems with the defrost timer on your Whirlpool mini refrigerator can also be caused by a malfunctioning control board. It can cause the freezer to freeze up or overwork. If the problem continues, you may need to replace the defrost timer or the control board.

Problems with drier filter

A dirty drier filter can lead to a clogged evaporator coil, which can make your refrigerator run very slowly and inefficiently. However, the problem can be easily solved. First, remove the drier and check for dirt and debris in the coils. If they are not dirty, you can clean them by following these easy steps.

You can also check for problems with the evaporator fan motor. This is another common problem with mini fridges. If the fan motor is not running properly, the mini fridge will not get cold enough. Also, if the evaporator fan motor isn’t working properly, the air circulation will be limited or nonexistent.

If the evaporator is clogged, you can replace the water filter. However, be aware that the ice volume may not improve until 24 hours have passed after the new filter has been installed.

Available for Amazon Prime