Why is My Whirlpool Mini Fridge Freezer Not Freezing?

whirlpool mini fridge freezer not freezing

If your Whirlpool mini fridge freezer is not freezing, there are a few possible causes. First, you should check whether there is power in the refrigerator. If there is, it is possible that a drier filter is blocking the freon from moving quickly enough to cool the fridge. Another potential cause is an ice layer on the evaporator coils.

drier filter prevents freon from moving quickly enough to cool the fridge

In some fridges, the drier filter is partially clogged. This can prevent the refrigerant from moving quickly enough. This can cause the temperature to drop. A technician can diagnose the problem by checking the temperature drop across the drier filter.

Ideally, the drier filter is replaced at the same time as the other refrigerant-based components. If you’ve noticed water accumulating on the filter, replace it immediately. This will help keep the cooling system operating properly. Filters should not be overheated, so it is important to wrap them in a wet cloth during brazing and installation. Make sure to replace the filter as soon as the refrigeration system is back up and running.

Start relay

If you’ve experienced the symptoms of a refrigerator freezing up, you may need to check the start relay. This small, electrical component is attached to the compressor motor. If the relay fails, the compressor is likely the problem. If you can’t get the refrigerator to cool, this may indicate a larger problem with the compressor itself.

The start relay is often easy to replace and is inexpensive to fix. You can test if the relay is defective by shaking it. If it makes a clicking noise, it may be the cause of your problem. To access the relay, turn off the refrigerator and remove the rear access panel. You can then look for the relay and replace it.

Ice layer on evaporator coils

When the ice layer on the evaporator coils of your Whirlpool mini fridge freezer begins to form, there may be something wrong. This layer forms when normal moisture freezes over and blocks the cooling of the freezer. This can affect the temperature control and lead to appliance failure.

The evaporator coil is located at the back of the freezer compartment. The coil has a cover that is removable with a screwdriver. The cover also acts as the top cover for the coil. When the door is closed, the door gasket completely seals the compartment, which keeps humid air out.

The ice buildup will eventually affect the quality of your food. It can also damage the coils and negatively impact the performance of the whole appliance. As a result, you should take good care of your kitchen appliance. If you notice that the ice layer has formed on the evaporator coils, you should check the defrost heater first. A faulty thermostat may also cause this problem.

Power outage

A power outage might have caused your refrigerator to stop freezing and the temperatures inside to be a bit too warm. To solve this problem, check the circuit breaker on your house and reset it. If this does not solve the problem, you may need to contact a technician.

First, make sure that your refrigerator is turned off before you turn it back on. To do this, power off the refrigerator and unplug it for at least five to ten minutes. If it has an automatic shutoff, then it will be off. To turn it back on, simply press the filter and smart grid buttons at the same time and hold them for three seconds. If you are using a manual shutoff, then you must check the power cords, wall sockets, and circuit breakers to make sure that they are still functioning.

A power outage will affect your fridge’s compressor, which is what powers the freezer’s cooling function. A worn or frayed power cord will prevent power from reaching the compressor, which may result in a short or even fire. Replace the power cord with a new one if the problem persists. A new one is inexpensive and will work with your freezer.

Clean condenser coils

The first step to troubleshooting a problem with your refrigerator is to clean the condenser coils. The coils are found at the bottom of your refrigerator, near the compressor. When they are dirty, they can’t dissipate heat effectively, causing your refrigerator to work harder than necessary to maintain the proper temperature.

You can clean the condenser coils by vacuuming them or using a dry brush. Dry brushes can be purchased online or in grocery stores. If your refrigerator isn’t working correctly, you may also need to check the door seal. If the door seal is leaking air, you may need to clean the condenser coils again.

You should clean your refrigerator’s condenser coils once or twice a year. However, if you have a pet or live in an area with high humidity, you may need to clean your condenser coils more frequently. To clean the coils, disconnect the power supply to the refrigerator first. Otherwise, you could endanger yourself.

Available for Amazon Prime